Scenario

Keep a well-performing, non-networked device e.g. a bar-code scanner, by connecting it to a PLC control system using its serial RS-232/422/485 or CAN-based interface. No need for any hardware or software changes.

Solution

Anybus® Communicator™ connects to the devices RS-232/422/485 interface and translates the serial or CAN data stream into a fieldbus or industrial Ethernet protocol. The device will then be represented as a Slave/Adapter on the PLC control network. 

• Versions available for all major fieldbus and industrial Ethernet networks
• Performs complete serial protocol conversion, no PLC function blocks or programming required
• Keep your existing device as is — No hardware or software changes needed!
  
  

Learn more about Anybus Communicator

See some customer sample configurations for Bar code scanners, Sensors and RFID applications

Scenario

Require integrated fieldbus and industrial Ethernet connectivity for a new range of e.g Sensors. Require a mix of traditional fieldbuses but also want to have PROFINET, EtherNet/IP and CC-Link IE Field to expand your global market reach. In addition, there are size, cost, time and conformance issues.

Solution

Anybus® CompactCom™ products are ready-made communication interfaces for fieldbus and industrial Ethernet, which you design in to give your sensor multi-network slave/adapter interface. The ideal choice is an Anybus Brick. Its small size, connector flexibility, cost and time to market make this a great fit. In addition, all Anybus CompactCom products are pre-conformed for full network compliance.

• Real-Time Industrial Ethernet with fast data transfer: up to 1500 bytes of process data each way with very low latency 
• Multi-network capability through just one in-design
• Available in Chip, Brick and Module formats
  
  

Learn more about Anybus CompactCom

Scenario

Need to connect two different cells on the factory floor where barcode scanners and sensors are connected to two different PLC systems. 

Solution

Anybus® X-gateways™ connect any TWO combinations of fieldbus or industrial Ethernet networks. The X-gateways primary function is fast transfer of cyclic I/O data between the two networks  

• Over 200 individual network combination gateway versions available - compatible with all PLC brands
• Master/Scanner interfaces for CANopen, EtherNet/IP, Modbus TCP and PROFIBUS can eliminate the need for an additional expense of a PLC Master Controller.
  
  

Learn more about Anybus X-gateway